Holley
Holley 543-111 Throttle Position Sensor for Terminator and Sniper EFI
One of the things that is most difficult things about the awesome conventional Sniper systems is getting the throttle cable from your carb to work with the sniper. The conventional Sniper is a bit wider than a carb, and that can cause some issues. Obviously, it is VERY important that the cable operate freely and without any chance of binding. DO NOT take chances with a cobbled together, zip tie throttle bracket.
We've found these throttle cable brackets to work very will in most swaps when using a GM cable.
This was exactly what I needed to get my LS swap completed and on the road. I used this on a 4150 Sniper, Holley mid-rise single plane intake and was able to reuse my GM throttle cable. I did have to shorten my throttle cable but that was easy.
Some products on our website are not legal for use on emissions-controlled vehicles. Consumers are responsible for following emissions laws and ensuring their modified vehicles comply with applicable regulations.
Emissions standards help protect air quality and public health. Agencies like the U.S. EPA, California Air Resources Board, and Environment Canada prohibit tampering with emissions systems, which is illegal under the U.S. Clean Air Act and can result in significant fines.
Scram Speed supports performance parts that meet emissions requirements. This information is general and may not apply to all vehicles or situations. Consumers are solely responsible for checking their local laws to ensure compliance.